CAD2D3D

Endura™ 8000 Maintenance It is generally good practice to perform a complete swivel inspection/ rebuild (overhaul) every 24 months. This helps ensure trouble-free operation without interruption of your process. It is also advisable to rebuild at evidence of product leakage into bearing module. Exercise caution so as not to lose any balls when removing them from the swivel module during disassembly. Flushing the grease chamber with a suitable, non-flammable solvent will allow the balls to fall out freely. Be sure the same number of balls are returned to each raceway. 2" and 3" Units -0 Step 1: Remove bearing plug bolts to access respective ball race. NOTE: 4" units are provided with threaded hex bolt in ieu of threaded plug/jam- nut combination. Step 2: Remove ball bearings via ball port in swivel body. NOTE: Non-flammable solvent may be used to help loosen lubricant and allow f or easier ball removal. Step 3: After all balls have been removed, carefully remove swivel tail from swivel body. Step 4: Carefully remove dynamic environmental seal. Clean and inspect all machined surfaces and carefully press new environmental seal into groove. NOTE: Lube seal with light machine oil. Step 5: Carefully align swivel tail and insert into body.