CAD2D3D三维模型免费下载，用3D看世界，让自动化更简单

WwWww.opw-es.com 2" and 3" Units = Step 6: Install ball bearings until bearing chamber is full. Chart below Step 7a: (2" and 3") With chamber completely 1 WS' rotate body/ shows the number of bearings per race. tail until one bearing is directly thread -plug hole. Install the ball-bearing plu bearing. Then installthe 8000 Series Replacement Bearings of a turn and QTY* | CARBON STEEL ’ STAINLESS STEEL “ H30647M H31300M ( H30647M H06780| thro p 7 from DSF Seal ment instructions. 3" 4" *For Dual Race Swivel, For Single Race divide by Greas s/RI \- OPW Swivels can be specified as greaseless, or non-lubricated, for certain applications. These swivels would typically be supplied as follows: ricated Applications o Stainless Steel (Grade 440) Ball Bearings would be supplied in lieu of Carbon Steel Balls. Grease fitting (p/n H30823M) would be removed and replaced with threaded plug (p/n H03288M). * Alight coating of LPS2 (LPS Labs) shall be applied to seals prior to installation. 1) Do not attempt any maintenance 2) OPW products do not eliminate possible exposure to 3) Proper seal and wetted-material part 人 WARNING Service while the equipment is in hazardous substances. The conditions of handling and use Selection is critical for Safe i operation. System pressure must are beyond our control, and we make no guarantee and operation. To assure maximum life be relieved and the product drained assume no liability for damages or injuries related to for the service intended, use only Failure to follow these before attempting any service on the use of our products. Follow the safety precautions those materials compatible with the warnings could result the unit. The line must be locked outlned in the Material Safety Data Sheets for the fluids being handled, Please note 5 i out while service is in progress. material being used. It is the responsibility of the user material being supplied and make in serious personal Proper thermal relief must be to comply with all federal, state and local regulations. certain that it is suited for the injury, property damage provided at all times while Always employ proper safety precautions and intended service. or product failure. equipment is in service. handling techniques. IMPORTANT: OPW products should be used in compliance with applicable federal, state, provincial, and local laws and regulations. Product selection should be based on physical specifications and limitations and compatibility with the environment and materials to be handled. OPW MAKES NO WARRANTY OF FITNESS FOR A PARTICULAR USE. Al illustrations and specifications in this literature are based on the latest product information available at the time of publication. OPW reserves the right to make changes at any time in prices, materials, specifications and models and to discontinue models without notice or obligation.