NANO17Ti（TITANIUM NANO 17）产品优势 Product Advantages
1001 [vanor7r trivaniom avo i f——
Product Advantages
Our Smallest 6-axis Sensor Now Available in a Titanium Version:
The Nano17Ti fits into restricted spaces of research applications and is
non-ferrous.
Extremely High Strength:
e EDM wire-cut from grade 5 titanium.
e Maximum allowable single-axis overload values are 4.9 to 19.6
times rated capacities.
High Signal-to-Noise Ratio: Silicon strain gages provide a signal 75
times stronger than conventional foil gages. This signal is amplified,
resulting in near-zero noise distortion. The Nano17Ti F/T transducer
The transducer is made of grade 5 titanium, with
Typical Applications integral interface plates made from high-strength
aircraft aluminum.
e Biomechanical research
e Measurements in highly magnetic environments
SENSING RANGES Calibrations
VES US-1.8-0.4
Fx, Fy (£lbf)
Fz (lbf)
Tx, Ty (zIbf-in) 0.4
Tz (+lbf-in)
RESOLUTION System Type*
Axes GTE Net/DAQ
US-3.6-0.8 US-7.2-1.6
6.3 12.6
0.8 1.6
Net/DAQ Net/DAQ
ENGLISH CALIBRATIONS
Fx, Fy (Ibf) 11514 1/3028 1/757 1/1514 2/757 1/757
Fz (Ibf) 211721 11721 5/2151 2/1721 10/2151 5/2151
Tx, Ty (Ibf-in) 2/13743 1/13743 10/34357 2/13743 5/8589 10/34357
Tz (Ibf-in) 1/5215 1/10430 2/5215 1/5215 10/13037 2/5215
SENSING RANGES Calibrations
Axes SI-8-0.05
Fx, Fy (N)
Fz (+N) 14.1 28 2 56.4
50 100 200
SI-16-0.1 SI-32-0.2
Tx, Ty (=Nmm)
Tz (+Nmm)
RESOLUTION System Type*
Axes Ejie Net/DAQ
Fx, Fy (N)
Fz (N) 1/341 1/682 2/341 1/341 2/171 1171
Tx, Ty (Nmm) 3/182 3/364 3/91 3/182 3/46 3/92
Tz (Nmm)
*CTL: Controller F/T System; Net: Net F/T System; DAQ: 16-bit DAQ F/T System The resolution is typical for most applications and can be improved with filtering.
Resolutions quoted are the effective resolution after dropping four counts of noise (Net/DAQ) or eight counts of noise (CTL). All sensors calibrated by ATI.
Applied loads must be within range in each of the six axes for the F/T sensor to measure correctly (refer to the transducer manual for complex loading information).
Net/DAQ Net/DAQ
METRIC CALIBRATIONS
10 VISIT WWW.ATI-IA.COM FOR CURRENT PRODUCT SPECIFICATIONS, 2-D DRAWINGS, AND 3-D CAD MODELS
